Filter
Top Products
234
CHAPTER 4 MENUS
[Simulator]
Figure 4.6-4 Break Dialog Box (Data)
- Breakpoint address
In this field, the address that sets a breakpoint is specified.
- Pass count
In this field, the count of times access with the specified attribute is to be made to that point (a
particular point) before causing a break is set. This field is only enabled for the simulator.
- Attribute
In this field, read access, write access, or both is specified.
- Breakpoint list
A list of data breakpoints currently being set is displayed.
State : Enable or disable is displayed.
Address : The set address is displayed.
Attribute : The attribute is displayed.
Pass count : The set pass count is displayed. In ( ), the count of times the PC has passed that
point by the present time is displayed.
Symbol : The symbol given to that address is displayed.
- [Setting] button, [Add] button
These buttons are used to set a breakpoint at the specified address. When an address that has been
already set in the breakpoint list is specified, the set data of the breakpoint at this address is changed.
- [Details] button
This button is used to set the details of a breakpoint at the specified address. For details, see 4.6.4.1
Breakpoint Details Setting.