Filter
Top Products
72
CHAPTER 3 Windows
The selected register is deleted from [Current Display Register] (lower part).
3. Set all the registers you want to delete by repeating the above operation.
4. Click the [OK] button.
■ Restoring registers to the initial status
Restore the registers in [Current Display Registers] to the initial status (status when SOFTUNE
WORKBENCH was installed) in the following procedure:
1. Click the right button of the mouse in the Register Window to display the shortcut menu, then select
[Display Setup] from the menu.
The display setting dialog box shown in Figure 3.10-2 opens.
2. Click the [Reset] button.
The registers in [Current Display Registers] (lower part of display register setting dialog box) are
restored to the initial status.
3. Click the [OK] button.