Filter
Top Products
273
CHAPTER 4 MENUS
-Load
Figure 4.7-21 Debugging Environment Setting (Load)
This sets the environment when loading a target file registered in the project.
-Pre-Post Load Batch File Specification
Pre- Load
This specifies the batch file to execute prior to the loading of the target file. This can be changed using
the Debugger's setup wizard.
Post- Load
This specifies the batch file to execute after the loading of the target file. This can be changed using
the debugger's setup wizard.
-Debug Information Only
This specifies whether or not to load only the debug information or not. When checked, only the
debug information is loaded.
-Auto-Map Setting
This specifies whether or not to enable the Auto-Map Setting. When checked, Auto-Map Setting is
enabled. This is valid the simulator only.