Filter
Top Products
25
CHAPTER 2 OPERATION
2.8 Setting Tools
When make or build is executed by SOFTUNE WORKBENCH, appropriate options must
be set in such tools as a compiler, assembler and linker. Set these options as follows:
■ Select the [Project]-[Setup Project] Menu
The [Set Project] dialog is opened. The option selected in the [Set Project] dialog box is applicable to two
or more projects. The applicable project configuration can be limited. For example, the settings of project
configurations A and B can be changed. The same setting can be also specified for all project
configurations.
Specify the project configuration in the [Setting Target] box, the project set in tree view, and select the tool
tab.
When the compiler, assembler and linker/librarian are selected, the category can be selected in the top tab
of the setting dialog box for each tool. After the top-down list is opened, select a category. When a category
was selected, the contents in the display are changed and the options included in each category can be set.
In most cases, compiler and assembler options need not be set except when output of list file and make or
build is executed under specific conditions. Set only linker options. For how to set linker options, see
Section 2.9 Setting Linker Options.
■ Click the [OK] button to complete tool setting
When setting all necessary tool options is completed, click the [OK] button. All the set options are
registered in the project; they become valid when make or build is executed.
Clicking the [Cancel] button cancels all the set options.
Note:
When the [Update] button is clicked during tool option setting, the previously set options cannot be
restored.