Filter
Top Products
30
CHAPTER 2 OPERATION
2.11 Debugging
The absolute file created as a result of normal termination of make/build can be
debugged immediately after SOFTUNE WORKBENCH has migrated to the debug
session.
■ Migrating SOFTUNE WORKBENCH to debug session
To enable SOFTUNE WORKBENCH to debug the absolute file, migrate it to the debug session.
To migrate SOFTUNE WORKBENCH to the debug session, select [Start Debug] from the [Debug] Menu
-First debugging after project creation
Setup Wizard for debuggers is started. Set the type of the debugger and others (4.7.2.4 Setup Wizard).
-Second or subsequent debugging after project creation
Start SOFTUNE WORKBENCH in the debugger mode that has been already set. To change the type of the
debugger, select the [Debug]-[End] Menu to terminate debugging once, and then change [Project Setup]
Menu.
■ Loading the target program
When SOFTUNE WORKBENCH enters the debug session, select [Load target program] from the [Debug]
Menu to load the target program. The created program is loaded to the debugger and all debugging
preparations are completed now.
■ Operating the debugger
For how to operate the debugger, see Chapter 3 Windows and Chapter 4 Menus in this manual.
For debugger commands and debugger output error messages, refer to the SOFTUNE WORKBENCH
Command Reference Manual
For the debugger functions (MCU common function, MCU chip dependency function), refer to the
SOFTUNE WORKBENCH Users Manual