Filter
Top Products
205
CHAPTER 4 MENUS
4.5.5.6 Section Disposition/Connection Specifying
This section explains how to set the section allocation/link option (linker option).
■ Section disposition/connection specifying
1. Click the [Linker] tab from the project setup dialog box.
2. Select the [Disposition/Connection] category.
The disposition/connection setup dialog box shown in Figure 4.5-32 opens.
3. Select [Auto Disposition] from the drop-down list.
(None/Mode 1/Mode 2)
The subsequent setting depends on how the section is concretely allocated.
Figure 4.5-32 Disposition/Connection Setup Dialog Box
■ When a section is allocated to the specified ROM/RAM area
1. Define the ROM/RAM area.
See Defining the ROM/RAM area.
2. Select the ROM/RAM area you want to set from [ROM/RAM Area List].
3. Click the [Set Section...] button.
The section setup dialog box shown in Figure 4.5-32 opens.