Filter
Top Products
31
CHAPTER 2 OPERATION
2.12 Executing Debugging Only
SOFTUNE WORKBENCH can be used as the conventional debuggers.
■ Creating a project
In SOFTUNE WORKBENCH, projects are a basis of all work. This is not an exception also at debugging.
For this reason, executing debugging only requires the creation of a project for debugging.
First, create the project for debugging and the workspace which stores the project in the following procedure:
1. Select [New] from the [File] Menu.
2. Select [Project/Workspace File] from the file open dialog box.
-Select the absolute format (ABS) from the new creation dialog box for the project.
-Specify a project name.
-Specify a project directory.
-Select a target MCU name and chip type.
■ Setting of Workspace
Perform setting common to projects to be stored in workspace.
1. Select [Set Workspace] from the [Project] menu.
2. When the [Set Workspace] dialog is opened, perform the following setting:
• Debug when workspace opened: Start debugging.
• Save setup information: Save.
■ Settings related to the debugger
1. Select [Project Setup] from the [Project] Menu.
2. When the setup dialog box opens, open the [Debug] tag and select [Setup] category:
3. Set a setup name.
A project name is set both in [Setup Name List] and [Valid Setup Name] as the default setup name.
Usually, setup names are identified by the type of the debugger to be used. However, if only one
debugger is used, the default name may be set as it is.
When the default name is used as is, select the default name already set in [Setup Name List], then click
the [Change Setup] button. When another name is used, specify [Setup Name], then click the [Add
Setup] button.
■ Setup Wizard
Clicking the [Add Setup] or [Change Setup] button starts the Setup Wizard for debuggers. Once Setup
Wizard has been started, set items according to instructions from Setup Wizard. For how to set items with
Setup Wizard, see Section 4.7.2.4 Setup Wizard.
When all settings with Setup Wizard are completed, click the [Complete] button.
When the [Project Setup] dialog box is redisplayed, click the [OK] button.
When all the above steps are completed, save the project, then close it once.