Filter
Top Products
306
APPENDIX
APPENDIX C Setting LAN Interface
To enable LAN communication, the LAN interface must be set at the PC and ICE sides.
Consult the LAN administrator when setting the IP address and a port address, etc.
■ Setting LAN interface at PC side
1. Install the TCP/IP protocol in network setting dialog on WindowsXP, WindowsMe, Windows2000,
Windows98 or WindowsNT4.0.
Install the TCP/IP protocol.
Click [Control Panel]-[Network] to set in WindowsMe, Windows98, or WindowsNT4.0.
Click [Control Panel]-[Network and Dial-up Connections]-[Local Area Connection]-[Property] to set in
WindowsXP and Windows2000.
2. Add the IP address, assigned to the ICE, to the HOSTS file.
Add the following items:
IP address Host name
For WindowsMe and Windows98, the IP address and host name are in the Windows directory.
For WindowsXP, Windows2000 and WindowsNT4.0, the IP address and host name are in SYSTEM32
\DRIVERS\ ETC. Users with administration authority must set the address and name.
3. Register the ICE port address and service name in the SERVICES file. At the default, 5001 is the
support address, and fjicesv is the service name. Register the following items:
fjicesv 5001/tcp
For WindowsMe and Windows98, the port address and service name are in the Windows directory.
For WindowsXP, Windows2000 and WindowsNT4.0, the port address and service name exist in
SYSTEM32 \DRIVERS\ ETC. Users, who possess an administrator authority, must set these address
and name.
■ Setting LAN interface at ICE side
In case of MB2141 ICE, this procedure is following:
1. Connect the ICE to the PC with the RS-232C interface.
2. Turn on the ICE.
3. Execute the [LAN Address] Menu from [SOFTUNE V3]- [F
2
MC-8L Family SOFTUNE WORKBENCH
Tool] of the Start Menu.
The LAN address setup program is started.
4. Select ICE name (MB2141).
5. Click [Set Communication] to set the RS-232C interface.
6. Click [Read] to read the current ICE setting status.
7. Set IP Address and Port Address. The IP address and port address set values at the PC side are displayed.
8. Usually, [Universal] is used as MAC Address. However, when using [Local] as MAC Address, consult
the LAN address administrator.
9. Select [Exit] from the [Setup] menu to exit the LAN address setup program.
10.Press the ICE reset button (button on rear) to reset the ICE.