Filter
Top Products
276
CHAPTER 4 MENUS
■ Procedure when the emulator (MB2146-09) is selected
1. Select the ICE type.
2. Click the [Next] button.
3. Select ( [USB] ) as the device type.
4. Click the [Next] button.
5. Specify the frequency (Main) and the Response speed mode.
6. Click the [Next] button.
7. Set whether or not to load the target file automatically during debugging.
8. Specify the batch files used before and after load as required.
Clicking the [Refer] button to the right of each input field enables batch file selection.
9. Click the [Next] button.
10. Select the item to be set in the setup file.
When [Specify] is selected, click the [Setup] button to open the item selection dialog box, select the
item to be set from the dialog box, then click the [OK] button.
11. Click the [Next] button.
12. Click the [Complete] button.
Emulator (MB2146-09) setup has been just completed.
■ Procedure when the simulator is selected
1. Set whether to load the target file automatically during debugging.
2. Specify the batch files used before and after load as required.
Clicking the [Refer] button to the right of each input field enables batch file selection.
3. Click the [Next] button.
4. Select the item to be set in the setup file.
When [Specify] is selected, click the [Setup] button to open the item selection dialog box, and select the
item to be set from the dialog box, then click the [OK] button.
5. Click the [Next] button.
6. Click the [Complete] button.
Simulator setup has been just completed.