Filter
Top Products
248
CHAPTER 4 MENUS
4.6.12 Load Target File
This section explains how to load the target file to be debugged by SOFTUNE
WORKBENCH.
■ Target file
An ABS format target file is to be debugged. This file is registered as a project target file.
Debugging can be started after the ABS format target file has been created. Use SOFTUNE
WORKBENCH to create a source program and execute compile/assemble and link. Creation of the ABS
format target file is enabled when the program is free from compile/assemble and link errors.
■ Loading the target file
Before loading the target file, select [Start debug] from the [Debug] Menu to place SOFTUNE
WORKBENCH in the debug session. When SOFTUNE WORKBENCH enters the debug session, select
[Load target file] from the [Debug] Menu to load the target file. The target file load state displays dialog
box shown in Figure 4.6-17 opens when the target file is being loaded.
Figure 4.6-17 Target File Load State Display Dialog Box
When loading the target file terminates, an entry point is set in the PC, the source line of the module
including the entry point is displayed, and the program stops.
Execute [Step] and [Go], etc., subsequently to continue debugging.