Filter
Top Products
11. D320L Configuration
Total number of pixels in line.
The total number of pixels in a line (= max. width).
total= (hor. Start active pixels) + (width active pixels) + (number of trailing blanking pixels).
Total number of lines in field.
The total number of lines in a field (= max height).
total=(vert. Start active pixels) + (height active pixels) + (number of trailing blanking lines)
Pixel Clock (kHz)
The clock speed of the digitizer. Typically, this will be 32 MHz (in single mode)
HSyncWidth
The width of the horizontal sync signal. This should always be 10 pixels.
VSyncWidth
The width of the vertical sync signal. This should always be 10 pixels.
Frame Rate
Vertical frequency of the input signal
11.2.2.3 The Timing Wizard
How to start up?
As the procedure is the same as for a D320 digitizer, see chapter "9. D320 Configuration", "The Timing
Wizard", page 139.
11.2.2.4 Lock mode
How to select
1. Check on the radio button of the desired Lock mode. (image 11-9)
Internal clock
The internal clock of the digitizer will be used (normal mode)
Lock to Input
The clock of the selected input will be used.
2. When Lock to Input is selec
ted, select the input out of the drop down box next to Lock to Input.
When applied, and the locking is successful, the Lockmode window will be displayed. (image 11-10)
The vertical frequency of th
e source is given as information.
3. Select algorithm for new timings.
R5976380 XLITE TOOLSET 16/03/2005
163