Filter
Top Products
13. Input Slots for D320 series
TheDDCsettingcanbeswitchoffbyselectingNoDDC.
No DDC No DDC communication between graphic card and the input module
Custom Custom file will be used to force the graphic card into certain resolution
VGA 85Hz refresh rate
SVGA 60Hz refresh rate
XGA 60Hz refresh rate
SXGA 60Hz refresh rate
SXGA 75Hz refresh rate
SXGA 85Hz refresh rate
UXGA 60Hz refresh rate
The graphic card will boot up in the selected display mode as far as the selected display mode is within
the card’s capabilities.
Before selecting Custom, place the corresponding file into the following directory : [install drive]:\Program
Files\Barco\XLite Toolset V2\LSToolset\Driver\DDCfiles.
The name of the file is standard
ized :
• for RGB analog module : D320rgban_custom.txt
• for DVI module : D320dvi_custom.txt
Pixel Phase
Fine adjustment for the sampling of the signal.
Clamp Place
To properly digitize the inc
oming signal, the dc offset of the input must be adjusted to fit the range of the
A/D converter. Most Graphic systems produce RGB signals with black at ground and white at +0.75V.
With this setting you can program the number of pixel times that should pass after the trailing edge of
HSYNC before clamping sta
rts.
Range 0 - 255
Clamp Duration
This sets the duration of the clamp. These both adjustments, providing considerable flexibility, to have a
good image
Range 0 - 255
13.8.3 Resolution Settings
Resolution Source
Set Resolution Source according the resolution of your source. When your graphic card has DCC com-
munication, the resolution source setting should be the same as DDC resolution.
The following settings are possible:
VGA
SVGA
XGA
R5976380 XLITE TOOLSET 16/03/2005
197