Filter
Top Products
12. D320Lite Configuration
Frame Rate
Vertical frequency of the input signal
12.3.3 The Timing Wizard
How to start up?
As the procedure is the same as for a D320 digitizer, see chapter "9. D320 Configuration", "The Timing
Wizard", page 139.
12.3.4 Lock mode
How to select
1. Check on the radio button of the desired Lock mode. (image 12-9)
Internal clock
The internal clock of the digitizer will be used (normal mode)
Lock to Input
The clock of the selected input will be used.
2. When Lock to Input is selected, select the input out of the drop down box next to Lock to Input.
When applied, and the locking is successful, the Lockmode window will be displayed. (image 12-10)
The vertical frequency of the source is given as information.
3. Select algorithm for new timings.
The following choices are possible:
Adjust the number of lines per
field
The processor will calculate the timings on Master digitizer.
When the calculated value of the number of lines is lower than
the active lines, an alert box will be displayed to try it via the
Adjust the number of pixels per line method.
Adjust the number of pixels per
line
The processor will calculate the timings on Master digitizer.
When the calculated value of the number of pixels per lines is
lower than the active number of pixels per line, an alert box will be
displayed to try it via the Adjust number of lines per field method.
When both methods give a alert box, it is not possible to lock on the selected source.
The Timings given in the New timings on Master Digitizer are given as information.
4. Click OK to continue.
Image 12-9
D320Lite sync generator, lock mode
R5976380 XLITE TOOLSET 16/03/2005 175