Filter
Top Products
13. Input Slots for D320 series
No DDC No DDC communication between graphic card and the input module
Custom Custom file will be used to force the graphic card into certain resolution
VGA 85Hz refresh rate
SVGA 60Hz refresh rate
XGA 60Hz refresh rate
SXGA 60Hz refresh rate
SXGA 75Hz refresh rate
SXGA 85Hz refresh rate
UXGA 60Hz refresh rate
The graphic card will boot up in the sele
cted display mode as far as the selected display mode is within
the card’s capabilities.
Before selecting Custom, place the corresponding file into the following directory : [install drive]:\Program
Files\Barco\XLite Toolset V2\LSToolset\Driver\DDCfiles.
The name of the file is standardized :
• for RGB analog module : D320rgban_custom.txt
• for DVI module : D320dvi_custom.txt
Brightness
Utilize the slider to determine a good brightness (overall light output) or click in the input field and enter
the desired value. The range is between 0 and 255.
Contrast
Utilize the slider to determine a
good color reproduction (between light and dark areas of the displayed
image) or click in the input field and enter the desired value. The range is between 0 and 255.
Pixel Phase
Fine adjustment for the sampling of the signal.
Clamp Place
To properly digitize the incoming signal, the dc offset of the input must be adjusted to fit the range of the
A/D converter. Most Graph
ic systems produce RGB signals with black at ground and white at +0.75V.
With this setting you can program the number of pixel times that should pass after the trailing edge of
HSYNC before clamping starts.
Range 0 - 255
Clamp Duration
This sets the duration of the clamp. These both adjustments, providing considerable flexibility, to have a
good image
Range 0 - 255
200
R5976380 XLITE TOOLSET 16/03/2005