Filter
Top Products
4. Autodetect Page
Default values will already be filled in.
Communication port Change the Communication port to the serial port as used for connecting
the PC to the Digitizer.
Baudrate
Read only value. Set up on 19200.
Databits
Read only value. Set to 8.
Parity Read only value. Parity is set to none. No parity check is used.
Stopbits Read only value. Stopbits is set to 1.
Status This setting is very important as it indicates as to whether the software
commands have effect on the system being talked to by the XLite ToolSet
software. When online all commands are sent and acted on, when off-line
all commands are not sent to the system devices.
When the Status is set to ’off-line’, during some adjustments in system configuration a message will appear
to asked if you want to stay working offline.(image 4-17)
Image 4-17
To stay working off line, click on OK. To return to online, click Cancel.
To finish the Communication settings:
• When the values are entered, click on
to update any changes made
• Click on
to exit without updating any changes and leaving the existing values unchanged.
Quick Status Change
of RS232
Click on the non selected square of the RS232 window to change the status.
Image 4-18
Status change RS232
When a green square is visible : online
When a red square is visible : offline
4.3 Start Autodectection
What will be executed?
Depending on the download mode the following will be executed during an autodetection:
Normal download mode (by default):
• Detection of all devices
• Addressing of all devices
• Downloading of device parameters
R5976380 XLITE TOOLSET 16/03/2005
23