Filter
Top Products
5. Wall Positioning Page
Image 5-64
Show rotation, result window
5.4.6.12 Simulate wire direction
What is possible ?
The wire
direction for each block, which correspond with the input side of the block, can be simulate by
a running light started by the first block connected with the controller and running through the string in
the direction of the wiring of the string. The pixels 1 and 3 of each block, input side of block, will light up
one a
fter each other during the simulation. This running light simulation should be exactly the same as
the function internal pattern, string direction which is executed on the wall itself. With this comparison it is
possible to set up the correct rotation of the blocks.
Once this function is activated, it stays active until it is switched off.
How to simulate ?
1. Right click in the workspace.
A popup window appears. (image 5-65)
2. Select Simulation and move your mouse to the right.
3. Check Simulate string direction.
When checked, the running light will start. (image 5-66)
Once this function is activated, it stays active until it is switched off.
70
R5976380 XLITE TOOLSET 16/03/2005