Filter
Top Products
Firewall Protection
147
ProSecure Unified Threat Management (UTM) Appliance
Create LAN DMZ Outbound Service Rules
You can change the default outbound policy or define rules that specify exceptions to the
default outbound policy. By adding custom rules, you can block or allow access based on the
service or application, source or destination IP addresses, and time of day. An outbound rule
can block or allow traffic between the DMZ and any internal LAN IP address according to the
schedule created in the Schedule screen.
To create an outbound LAN DMZ service rule:
1. In the LAN DMZ Rules screen, click the Add table button under the Outbound Services
table. The Add LAN DMZ Outbound Service screen displays:
Figure 74.
2. Enter the settings as explained in Table 27 on page 130.
3. Click Apply. The new rule is now added to the Outbound Services table. The rule is
automatically enabled.
Create LAN DMZ Inbound Service Rules
The Inbound Services table lists all existing rules for inbound traffic. If you have not defined
any rules, no rules are listed. By default, all inbound traffic (from the LAN to the DMZ) is
blocked.
To create an inbound LAN DMZ service rule:
1. In the LAN DMZ Rules screen, click the Add table button under the Inbound Services
table. The Add LAN DMZ Inbound Service screen displays: