NETGEAR STM150EW-100NAS Router User Manual


 
xDSL Network Module for the UTM9S and UTM25S
575
ProSecure Unified Threat Management (UTM) Appliance
Note: You can also configure the failure detection method for the
auto-rollover mode on the Advanced Options screen for the DSL
interface. This procedure is discussed in Configure the Failure
Detection Method on page 565.
IMPORTANT:
Each computer or router on your network has a unique 48-bit local
Ethernet address. This is also referred to as the computer’s Media
Access Control (MAC) address. The default, on the WAN Advanced
Options screen, is Use Default Address. If your ISP requires MAC
authentication and another MAC address has been previously
registered with your ISP, then you need to enter that address on the
Advanced Options screen for the DSL interface.
To configure advanced WAN options:
1. Select Network Config > WAN Settings.
2. Click the Edit button in the Action column of the SLOT-x entry. The SLOT-x ISP Settings
screen displays (see Figure 323 on page 554, which shows the SLOT-2 ISP Settings
screen as an example).
3. Click the Advanced option arrow in the upper right of the screen. The SLOT-x Advanced
Options screen displays. (The following figure shows the SLOT-2 Advanced Options screen
as an example.)
Figure 338.