Filter
Top Products
Monitor System Access and Performance
463
ProSecure Unified Threat Management (UTM) Appliance
To monitor traffic limits on each of the WAN ports, and for the UTM9S and UTM25S,
also on the xDSL (SLOT-1 or SLOT-2) and USB ports:
1. Select Network Config > WAN Metering. On the multiple WAN port models, the WAN
Metering tabs display, with the WAN1 Traffic Meter screen (or, for the UTM9S and
UTM25S, the WAN1 screen) in view (the following figure shows the WAN1 Traffic Meter
screen of the UTM50). On the single WAN port models, the WAN Traffic Meter screen
displays.
The Internet Traffic Statistics section in the lower part of the screen displays statistics on
Internet traffic through the WAN port. If you have not enabled the traffic meter, these
statistics are not available.
Figure 271.
2. Enter the settings as explained in the following table: