NETGEAR STM150EW-100NAS Router User Manual


 
Virtual Private Networking Using IPSec, PPTP, or L2TP Connections
324
ProSecure Unified Threat Management (UTM) Appliance
Note: This is the name for the IPSec configuration that is used only for the
VPN client, not during IPSec negotiation. You can view and change this name
in the tree list pane. This name needs to be a unique name.
The IPSec pane displays in the Configuration Panel screen, with the IPSec tab selected
by default.
Figure 191.
3. Specify the settings that are explained in the following table.
Table 81. VPN client IPSec configuration settings (Mode Config)
Setting Description
VPN Client address This field is masked out because Mode Config is selected. After an IPSec
connection is established, the IP address that is issued by the UTM displays in this
field (see Figure 196 on page 328).
Address Type Select Subnet address from the drop-down list.
Remote host address The address that you need to enter depends on whether you have specified a LAN
IP network address in the Local IP Address field on the Add Mode Config Record
screen of the UTM:
If you left the Local IP Address field blank, enter the UTM’s default LAN IP
address as the remote host address that opens the VPN tunnel. For example,
enter 192.168.1.1.
If you specified a LAN IP network address in the Local IP Address field, enter
the address that you specified as the remote host address that opens the VPN
tunnel.