NETGEAR STM150EW-100NAS Router User Manual


 
3G/4G Dongles for the UTM9S and UTM25S
606
ProSecure Unified Threat Management (UTM) Appliance
4. Configure the settings as explained in the following table:
Table 154. USB ISP settings
Setting Description
3G Dongle Details
Card Type The card type is a fixed field that states 3G/4G.
Enable 3G Service Select the Enable 3G Service check box to enable the 3G/4G service.
Connection Settings
Idle Timeout Select the Keep Connected radio button to keep the connection always on. To log out
after the connection is idle for a period:
1. Select the Idle Timeout radio button.
2. In the time-out field, enter the number of minutes to wait before disconnecting.
This is useful if your ISP charges you based on the period that you are logged in.
Connection Reset Select the Connection Reset check box to specify a time when the 3G/4G connection
is reset, that is, the connection is disconnected momentarily and then reestablished.
Then, specify the disconnect time and delay.
Disconnect Time Specify the hour and minutes when the connection should be
disconnected.
Delay Specify the period in seconds after which the connection
should be reestablished.
Internet (IP) Address
Note: Click the Current IP Address link to see the currently assigned IP address.
Get Dynamically
from ISP
If your ISP has not assigned you a static IP address, select the Get Dynamically from
ISP radio button. The ISP automatically assigns an IP address to the UTM9S or
UTM25S using DHCP network protocol.
Use Static IP
Address
If your ISP has assigned you a fixed (static or permanent) IP address, select the Use
Static IP Address radio button, and enter the following settings:
IP Address Static IP address assigned to you. This address identifies the
UTM9S or UTM25S to your ISP.
Subnet Mask The subnet mask is usually provided by your ISP.
Gateway IP Address The IP address of the ISP’s gateway is usually provided by
your ISP.
Domain Name Server (DNS) Servers
Get Automatically
from ISP
If your ISP has not assigned any Domain Name Server (DNS) addresses, select the
Get Automatically from ISP radio button.