NETGEAR STM150EW-100NAS Router User Manual


 
Manually Configure Internet and WAN Settings
86
ProSecure Unified Threat Management (UTM) Appliance
Configure Load Balancing (Multiple WAN Port Models)
To configure load balancing:
1. Select Network Config > WAN Settings > WAN Mode. The WAN Mode screen
displays:
Figure 47.
Note: You cannot configure load balancing when you use a PPPoE
connection and have selected the Idle Timeout radio button on the
WAN ISP Settings screen (single WAN port models) or on one of the
WAN ISP Settings screens (multiple WAN port models); to use load
balancing on a PPPoE connection, select the Keep Connected
radio button. For more information, see Figure 41 on page 76 and
the accompanying PPPoE information in Table 14 on page 76.
2. In the Load Balancing Settings section of the screen, configure the following settings:
a. Select the Load Balancing Mode radio button.
b. From the corresponding drop-down list on the right, select one of the following load
balancing methods:
Weighted LB. With weighted load balancing, balance weights are calculated
based on WAN link speed and available WAN bandwidth. This is the default
setting and the most efficient load-balancing algorithm.
Round-robin. With round-robin load balancing, new traffic connections are sent
over a WAN link in a serial method irrespective of bandwidth or link speed. For
example on a UTM150, if the WAN1, WAN2, and WAN3 interfaces are active in
round-robin load balancing mode, an HTTP request could first be sent over the
WAN1 interface, then a new FTP session could start on the WAN2 interface, and
then any new connection to the Internet could be made on the WAN3 interface.