Filter
Top Products
Virtual Private Networking Using IPSec, PPTP, or L2TP Connections
282
ProSecure Unified Threat Management (UTM) Appliance
Note: This is the name for the authentication phase that is used only for the
VPN client, not during IKE negotiation. You can view and change this name in
the tree list pane. This name needs to be a unique name.
The Authentication pane displays in the Configuration Panel screen, with the
Authentication tab selected by default.
Figure 167.
4. Specify the settings that are explained in the following table.
Table 67. VPN client authentication settings
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the UTM. For example, enter
10.34.116.22.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the UTM. For example, enter I7!KL39dFG_8. Confirm the key in the
Confirm field.
IKE Encryption Select the 3DES encryption algorithm from the drop-down list.
Authentication Select the SHA1 authentication algorithm from the drop-down list.
Key Group Select the DH2 (1024) key group from the drop-down list.
Note: On the UTM, this key group is referred to as Diffie-Hellman
Group 2 (1024 bit).