NETGEAR STM150EW-100NAS Router User Manual


 
3G/4G Dongles for the UTM9S and UTM25S
616
ProSecure Unified Threat Management (UTM) Appliance
Destination Network. The Internet locations (based on their IP address) that are
covered by the protocol binding rule.
Action. The Edit button provides access to the Edit Protocol Binding screen for the
corresponding service.
2. Click the Add table button below the Protocol Bindings table. The Add Protocol Binding
screen displays:
Figure 355.
3. Configure the protocol binding settings as explained in the following table:
Table 156. Add Protocol Binding screen settings
Setting Description
Service From the drop-down list, select a service or application to be covered by this rule. If the
service or application does not appear in the list, you need to define it using the Services
screen (see Outbound Rules (Service Blocking) on page 129).
Local Gateway From the drop-down list, select the DSL interface or one of the WAN interfaces.
Source Network The source network settings determine which computers on your network are affected by
this rule. Select one of the following options from the drop-down list:
Any All devices on your LAN.
Single address In the Start IP field, enter the IP address to which the rule is applied.
Address Range In the Start IP field and End IP field, enter the IP addresses for the
range to which the rule is applied.
Group 1–Group 8 If this option is selected, the rule is applied to the devices that are
assigned to the selected group.
Note: You can also assign a customized name to a group (see
Change Group Names in the Network Database on page 115).