NETGEAR STM150EW-100NAS Router User Manual


 
Virtual Private Networking Using IPSec, PPTP, or L2TP Connections
266
ProSecure Unified Threat Management (UTM) Appliance
Use the IPSec VPN Wizard for Client and Gateway
Configurations
Create Gateway-to-Gateway VPN Tunnels with the Wizard
Create a Client-to-Gateway VPN Tunnel
You can use the IPSec VPN Wizard to configure multiple gateway or client VPN tunnel
policies.
The following section provides wizard and NETGEAR ProSafe VPN Client software
configuration procedures for the following scenarios:
Using the wizard to configure a VPN tunnel between two VPN gateways
Using the wizard to configure a VPN tunnel between a VPN gateway and a VPN client
Configuring a VPN tunnel connection requires that you specify all settings on both sides of
the VPN tunnel to match or mirror each other precisely, which can be a daunting task. The
VPN Wizard efficiently guides you through the setup procedure with a series of questions that
determine the IPSec keys and VPN policies it sets up. The VPN Wizard also configures the
settings for the network connection: security association (SA), traffic selectors, authentication
algorithm, and encryption. The settings that are used by the VPN Wizard are based on the
recommendations of the VPN Consortium (VPNC), an organization that promotes
multivendor VPN interoperability.
Create Gateway-to-Gateway VPN Tunnels with the Wizard
Figure 151.
To set up a gateway-to-gateway VPN tunnel using the VPN Wizard:
1. Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays (see the
following figure, which shows the VPN Wizard screen for the UTM50, and contains an
example).
The About VPN Wizard section of the VPN Wizard screen shows the following minor
differences for the various UTM models:
Single WAN port models. No WAN selection drop-down lists and no Enable RollOver
check box.