NETGEAR STM150EW-100NAS Router User Manual


 
Virtual Private Networking Using IPSec, PPTP, or L2TP Connections
294
ProSecure Unified Threat Management (UTM) Appliance
To delete one or more IKE polices:
1. Select the check box to the left of each policy that you want to delete, or click the Select
All table button to select all IKE policies.
2. Click the Delete table button.
For information about how to add or edit an IKE policy, see Manually Add or Edit an IKE
Policy on page 294.
Note: You can delete or edit an IKE policy for which the VPN policy is
active without first disabling or deleting the VPN policy. In earlier
firmware releases of the UTM, you first had to disable or delete the
VPN policy, but this restriction has been removed.
Manually Add or Edit an IKE Policy
To add an IKE policy manually:
1. Select VPN > IPSec VPN. The IPSec VPN submenu tabs display with the IKE Policies
screen in view (see the previous figure).
2. Under the List of IKE Policies table, click the Add table button. The Add IKE Policy screen
displays (see the following figure, which shows a multiple WAN port model screen). The
WAN drop-down lists (next to Select Local Gateway) are shown on the Add IKE Policy
screen for the multiple WAN port models but not on the Add IKE Policy screen for the single
WAN port models.