Filter
Top Products
Monitor System Access and Performance
495
ProSecure Unified Threat Management (UTM) Appliance
The following table explains the fields of the Detailed Status screen:
Table 127. Detailed Status screen fields
Item Description
LAN Port Configuration
The following fields are shown for each of the LAN ports.
VLAN Profile The name of the VLAN profile that you assigned to this port on the LAN Setup
screen (see Assign and Manage VLAN Profiles on page 100). If the VLAN is not
enabled on this port, the default profile (with VLAN ID 1) is assigned automatically.
VLAN ID The VLAN ID that you assigned to this port on the Add VLAN Profile screen (see
Configure a VLAN Profile on page 103). If the default VLAN profile is used, the
VLAN ID is 1, which means that all tagged and untagged traffic can pass on this
port.
MAC Address The MAC address of this port. All LAN ports share the same MAC address if they
are part of the default VLAN. However, if LAN port 4 (UTM5, UTM10, UTM25, and
UTM150) or LAN port 6 (UTM50) is enabled as the DMZ port, its MAC address is
changed to the MAC address of the WAN2 interface plus 1. (For example, if the
MAC address of the WAN2 interface is 00:26:f2:b5:db:80, the MAC address of the
DM port is 00:26:f2:b5:db:81.) For information about configuring the DMZ port, see
Configure and Enable the DMZ Port on page 117.
IP Address The IP address for this port. If the VLAN is not enabled on this port, the IP address
is the default LAN IP address (192.168.1.1). For information about configuring
VLAN profiles, see Configure a VLAN Profile on page 103.
Subnet Mask The subnet mask for this port. If the VLAN is not enabled on this port, the subnet
mask is the default LAN IP subnet mask (255.255.255.0). For information about
configuring VLAN profiles, see Configure a VLAN Profile on page 103.
DHCP Status The status can be either DHCP Enabled or DHCP Disabled. For information about
enabling DHCP for this port, see Configure a VLAN Profile on page 103.
WAN Info, xDSL information in SLOT-1 Info or SLOT-2 Info, and USB Info
Note: For the UTM9S and UTM25S only: DSL information is shown in the SLOT-1 Info or SLOT-2 Info section,
depending on the slot in which the xDSL network module is installed. All other fields that are shown in the
SLOT-1 Info or SLOT-2 Info section are also shown in the WAN Info sections.
Note: The USB information in the USB Info section applies to the UTM9S and UTM25S only.
The following fields are shown for each of the WAN ports and for the slot in which the xDSL network module is
installed:
WAN Mode The WAN mode can be Single Port, Load Balancing, or Auto Rollover. For
information about configuring the WAN mode, see Configure the WAN Mode on
page 80.
Card Type (UTM9S and
UTM25S only)
The configuration of the xDSL network module: VDSL or ADSL.
Daughter Card (UTM9S
and UTM25S only)
The type of supported annex on the xDSL network module: Annex A or Annex B
(VDSL_ANNEXA, VDSL_ANNEXB, ADSL_ANNEXA, or ADSL_ANNEXB).