Filter
Top Products
Introduction
35
ProSecure Unified Threat Management (UTM) Appliance
Rear Panel UTM9S and UTM25S
The rear panel of the UTM9S and UTM25S includes the cable lock receptacle, the console
port and console switch, the Factory Defaults reset button, the AC power connection, and the
power switch.
Figure 11. Rear panel of the UTM9S and UTM25S
Viewed from left to right, the rear panel of the UTM9S and UTM25S contains the following
components:
1. Cable security lock receptacle.
2. Factory Defaults Reset button. Using a sharp object, press and hold this button for about
8 seconds until the front panel Test LED flashes to reset the UTM to factory default settings.
Configuration changes are lost, and the default password is restored.
3. Console switch to select the console connection: Main Board (left position), Slot 1 (middle
position), or Slot 2 (right position).
4. Console port (9600,N,8,1). Port for connecting to an optional console terminal. The port has
a DB9 male connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5)
and (7) Gnd.
5. AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).
6. Power On/Off switch.
Security lock
receptacle
Console port
Factory Defaults
AC power
receptacle
reset button
Console switch
Power
switch