Filter
Top Products
A6 A5 A4 A3 A2 Al
I
Switch in
Down Position
= Logic 1
Indicates Switch
in Down Position
Figure 1. HP-IB Address Switch (Shown in Factory Preset Position)
The HP-IB address may also be changed from the front panel or programmed via a controller
using a special shift key function (KSP). This address remains in effect as long as the
instrument memory has power from either the ac line or the internal battery. However, if
this stored address is lost, the default address is the factory preset decimal 18 (ASCII 2R).
For additional information on the HP-IB address, refer to the Operating and Programming
Manual.
Storage and Shipment
Environment
The instrument may be stored or shipped in environments within the following limits:
Temperature . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
-40°C to +75°c
Humidity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...5% to 90% at 0°C to 40°C
Altitude . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Up to 15,240 meters
(50,000 feet)
The instrument should be protected from temperature extremes which might cause
condensation within the instrument.
Original Packaging
It is recommended that the original factory packaging materials be retained for use
when shipping the instrument. If original packaging material cannot be retained,
packaging materials identical to those used in factory packaging are available through the
Hewlett-Packard offices. Part numbers and descriptions of the packaging materials are listed
in Figure 2.
The combined weight of the two instrument sections is approximately 50 kg (112 lbs).
Because of the weight involved, do not package the instrument sections fastened together as
one unit. The instrument sections must be separated and packaged in separate containers.
The quantity of packaging materials in Figure 2 is for only one instrument section.
If the instrument is being returned to Hewlett-Packard for servicing, attach a tag to each
carton indicating the type of service required, return address, model number, and full serial
number. For your convenience, a supply of tags is included at the end of this section. Also,
mark each container FRAGILE to assure careful handling. In any correspondence, refer to the
instrument by model number and full serial number.
6 General Information