5.
6.
7.
When installing new 10 MHz Standard, check that rear studs are supported by both rear
rubber mounts and reconnect 87 (gray/violet) cable and 6-pin connector (red wire to rear
pin). Fasten 10 MHz Standard to RF Section with two screws
0.
Replace All YTO Loop. Replace three screws removed in step 2 and reconnect cable
connector
0.
When installing new 10 MHz Standard, check that rear studs are supported by both rear
rubber mounts and reconnect 87 (gray/violet) cable and 6-pin connector (red wire to rear
pin). Fasten 10 MHz Standard to RF Section with two screws
0.
Replace All YTO Loop. Replace three screws removed in step 2 and reconnect cable
connector
0.
Replace RF Section bottom cover and reconnect ac line cords.Replace RF Section bottom cover and reconnect ac line cords.
REARREAR
(2 PLACE
a
1
Figure 1. A22 10 MHz Standard Replacement
2 A22