Filter
Top Products
4 - 79
4 POSITIONING SIGNALS
4.3 Motion Registers (#)
There are motion registers (#0 to #8191) in the Motion CPU. #8000 to #8063 are used
as SV43 dedicated device and #8064 to #8191 are used as the servo monitor device.
(1) SV43 dedicated device (#8000 to #8063)
These devices are reserved by the system. Do not use them by user side.
(2) Servo monitor devices (#8064 to #8191) ................. Monitor device
Information about "servo amplifier type", "motor current" and "motor speed" for
each axis is stored the servo monitor devices.
The details of the storage data are shown below.
Axis
No.
Device No. Signal name
1 #8064 to #8067
2 #8068 to #8071
3 #8072 to #8075
Signal name
(Note-1)
Signal description Refresh cycle
Signal
direction
4 #8076 to #8079
5 #8080 to #8083
+0 Servo amplifier type
0 : Unused
256 : MR-J3-B
When the servo amplifier power-on
6 #8084 to #8087 +1 Motor current 0.1[%]
7 #8088 to #8091
+2
8 #8092 to #8095 +3
Motor speed
0.1[r/min]
Operation cycle 1.7[ms] or less: Operation cycle
Operation cycle 3.5[ms] or more: 3.5[ms]
Monitor
device
9 #8096 to #8099
10 #8100 to #8103
(Note-1) : The value that the lowest servo monitor device No. was added "+0, +1 ···" on each axis is shown.
11 #8104 to #8107
12 #8108 to #8111
13 #8112 to #8115
14 #8116 to #8119
15 #8120 to #8123
16 #8124 to #8127
17 #8128 to #8131
18 #8132 to #8135
19 #8136 to #8139
20 #8140 to #8143
21 #8144 to #8147
22 #8148 to #8151
23 #8152 to #8155
24 #8156 to #8159
25 #8160 to #8163
26 #8164 to #8167
27 #8168 to #8171
28 #8172 to #8175
29 #8176 to #8179
30 #8180 to #8183
31 #8184 to #8187
32 #8188 to #8191