Filter
Top Products
APP - 15
A
PPENDICES
Table 1.7 Motion program running error (500 to 699) list (Continued)
Control mode
Error
code
Control program
Axis designation program
(positioning)
JOG
Manual pulse generator
Home position return
OSC
Error cause
Error
processing
Corrective action
584
Cancel start (G24) program No. error • Correct the Motion program
No..
585
High-speed oscillation (G25) amplitude range error • Correct the high-speed
oscillation (G25) amplitude
range.
586
High-speed oscillation (G25) starting angle range
error
• Correct the high-speed
oscillation (G25) starting angle
range.
587
High-speed oscillation (G25) frequency range error • Correct the high-speed
oscillation (G25) frequency
range.
591
A fault occurred in the system. • Explain the error symptom and
get advice from our sales
representative.
592
The axis name is not correct. • Match the axis name with the
one in the system settings.
593
O No. designated in the specified Motion program is
not correct.
O No. specified with CALL, GOSUB/GOSUBE is not
registered.
O No. specified with G24 (cancel start) is not
correct.
• Correct the O***; part.
• Correct O No. specified with
CALL, GOSUB/GOSUBE.
• Set the correct O No..
594
The axis not specified with SVST is specified in the
Motion program.
• Correct the SVST instruction.
• Correct the Motion program.
600
Number of helical interpolation pitches error
Number of helical interpolation pitches is outside the
range of 1 to 999.
• Set the number of helical
interpolation pitches within the
range of 0 to 999.
610
IF [condition] THEN SET/RST/OUT statements are
in error.
Decelera-
tion stop.
Control
program
ends.
• Correct the instructions.
611
There are unusable instructions and incorrect
instructions in the control program.
• Correct the instructions.
612
The program of number set as automatic starts not
registered. Or, the axis designation program is
started automatically.
• Correct the parameters.
613
The operating axis is specified with CALL,
GOSUB/GOSUBE.
614
The program number started by CALL,
GOSUB/GOSUBE is outside the range of 1 to 1024.
615
The program started by CALL, GOSUB/GOSUBE is
not registered.
Program
ends.
• Correct the CALL,
GOSUB/GOSUBE instruction.