Filter
Top Products
7 - 20
7 AUXILIARY AND APPLIED FUNCTIONS
(3) Home position return execution
Home position return by the proximity dog type 2 is executed using the CHGA
instruction in Section 7.3.16.
When the home position return request is ON, the proximity dog type 2 home
position is also made even G28 of the Motion program.
[Cautions]
(1) A system which the servomotor can rotate one time or more is required.
(2) When a servomotor stops with specified condition enables and rotates one time
after proximity dog ON, make a system for which does not turn OFF the external
upper/lower stroke limit.
(3) Keep the proximity dog ON during deceleration from the home position return
speed to the creep speed.
If the proximity dog turns OFF before deceleration to the creep speed, a
deceleration stop is made and the next zero point is set as the home position.
(4) If home position return is executed in the proximity dog ON, it starts with the creep
speed.
(5) When home position return retry function is not set, if home position return is
executed again after home position return completion, a minor error "home
position return completion signal is turning ON at the proximity dog type home
position return start" (error code: 115) will occur, the home position return is not
executed.
(6) When "1 : Not need to pass motor Z phase after the power supply is switched on"
is selected in the "function selection C-4" of servo parameter (expansion setting
parameter), even if it does not pass zero at the servo amplifier power ON, the zero
pass signal (M2406+20n) turns ON. This operation is the same as proximity dog
type 1.
(7) If in-position signal (M2402+20n) does not turn ON, home position return is not
ended.