Filter
Top Products
E6581301
F-75
6
■
■■
■
An example of setting: When HJ
HJHJ
HJ is
, and H
HH
H is
800
0
1000
0
Panel indication
800
0
Panel indication
Panel indication
H
=
,
H
=
H
=
,
H
=
H
=
,
H
=
0 80(Hz)
0 80(Hz)
Output frequency
Output frequency
Output frequency
80 (Hz)
H
H
H
200
0
6.36.3 Changing the steps in which the value displayed changes
H
HH
H : Changing step selection 1 (pressing a panel key once)
H
HH
H : Change step selection 2 (panel display)
Caution
MANDATORY
When using H function, set the parameter following.
H(Changing step selection 1) Ჶ H(operation start frequency)
HᲢoperation start frequency hysteresisᲣ=
If you press the Up key on the panel repeatedly to increase the frequency while His set to any value other than
0, the “JK” alarm will appear immediately before the frequency exceeds the WN(Upper limit frequency) and the
frequency will stop increasing. Similarly, if you press the Down key on the panel repeatedly to decrease the
frequency, the “NQ” alarm will appear immediately before the frequency decreases below the NN(lower-limit
frequency) and the frequency will stop decreasing.
•
••
•
Function
These parameters are used to specify steps in which the command value or standard monitor output
frequency displayed on the panel changes each time you press the up or down key to set a frequency on
the operation panel.
Note: The settings of these parameters have no effect when the free unit selection (
H
HH
H) is enabled.
■
■■
■ When H
HH
H is not
, and H
HH
H is
(disabled).
Under normal conditions, the panel frequency command value increases in steps of 0.1Hz each time you press the
key. If H is not 0.00, the frequency command value will increase by the value with H each time you
press the key. Similarly, it will decrease by the value set with H each time you press the key.
In this case, the output frequency displayed in standard monitor mode changes in steps of 0.1Hz, as usual.
■
■■
■ When H
HH
H is not
, and H
HH
H is not
.
The value displayed on the panel also can be changed in steps.
Output frequency displayed in standard monitor
= Internally output frequency ×
H
H
Title Function Adjustment range Default setting
H
Changing step selection 1
(pressing a panel key once)
.:Disabled
.~HJ Hz
.
H
Changing step selection 2
(panel display)
:Disabled
~