Filter
Top Products
E6581301
D-1
4
4. Searching and setting parameters
There are two types of setting mode quick mode and standard setting mode.
Quick mode : EASY key: ON
Eight frequently used basic parameters are just
displayed (Factory default position).
Quick mode (EASY)
Title Function
CW Automatic function setting
RV
V/f control mode selection
HJ
Maximum frequency
CEE
Acceleration time 1
FGE
Deceleration time 1
VJT
Motor
electronic thermal
protection level 1
HO
FM terminal meter adjustment
RUGN
Registered
p
arameter display selec
tion
Parameters you selected can be displayed by changing
the parameter. (Up to 32 parameters)
Standard setting mode : EASY key: OFF
Both basic and extended all parameters are displayed.
Basic parameters : This parameter is a basic parameter for the
operation of the inverter.
For details of basic parameters, refer to Section 5.
For parameter settings, refer to Section 11.
Extended parameters :The parameters for detailed and special
setting.
For details of extended parameters, refer to Section 6.
For parameter settings, refer to Section 11.
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while the
inverter is running.
[Basic parameters]
CW (Automatic acceleration/deceleration)
CW (Automatic torque boost)
CW (Automatic function setting)
EOQF (Command mode selection)
HOQF (Frequency setting mode selection 1)
RV (V/f control mode selection)
XN (Base frequency 1)
XNX (Base frequency voltage 1)
HJ (Maximum frequency)
WXU (Auto-restart control selection)
WXE (Regenerative power ride-through control)
RD (Dynamic braking selection)
RDT (Dynamic braking resistance)
RDER (Allowable continuous braking resistance)
V[R (Factory default setting)
To write-protect extended parameters during operation, refer to Section 11.