Filter
Top Products
E6581301
G-1
7
7. Operation with external signal
7.1 External operation
The inverter can be freely controlled externally.
Parameters must be differently set depending on the operation method. Make sure of the operation method before
setting parameters, and set parameters properly to the operation mode according to the procedure mentioned below.
[Steps in setting parameters]
Check of external signal
conditions
In case of control panel operation the frequency
HOQF
=
(
Operation panel input enabled
)
In case of set the frequency with external input
HOQF
=
(VI/II (voltage/current input))
(RR/S4 (potentiometer/voltage input))
(RX (voltage input))
(2-wire RS485 communication input)
(4-wire RS485 communication input)
(Communication option input)
(Optional AI1
(Differential current input)
)
(Optional AI2 (voltage/current input))
(Motor operated pot mop setting)
(RP pulse input)
(High speed pulse input)
- (Unsupported)
Operation signal:
operation panel
Speed command:
operation panel
Refer to
Section
5.
5
Example 1.
Operation signal:
terminal board
Speed command:
operation panel
Operation signal:
operation panel
Speed command:
terminal board
Operation signal:
terminal board
Speed command:
terminal board
In case of run/stop with external input
EOQF
=
(Terminal input enabled
) *
(2-wire RS485 communication input)
(4-wire RS485 communication input)
(Communication option input)
*Sink logic and source logic (logic of input/output
terminal) are switchable to each other.
For details, refer to Section 2.3.2
.
In case of control panel operation command input
EOQF
=
(
Operation panel input enabled
)
Refer to
Section
5.
5
Example 2.
Refer to
Section
5.
5
Example 3.
Refer to
Section
5.
5
Example 4.
┨