Filter
Top Products
8-13
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 8 Configuring Ethernet Virtual Connections
How to Configure EVC Default Encapsulation
How to Configure EVC Default Encapsulation
• Configuring EVC Default Encapsulation with Bridge-Domain
• Configuring EVC Default Encapsulation with Xconnect
• Verifying EVC Default Encapsulation with Bridge-Domain
• Verifying EVC Default Encapsulation with Xconnect
• Configuration Examples for EVC Default Encapsulation
Configuring EVC Default Encapsulation with Bridge-Domain
Complete the following steps to configure EVC default encapsulation for a bridge-domain.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. service instance instance-id ethernet
5. encapsulation default
6. bridge-domain bridge-id
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface
type number
Example:
Router(config)# interface GigabitEthernet0/4
Specifies an interface type and number, and enters interface
configuration mode.
Step 4
service instance
instance-id
ethernet
Example:
Router(config-if)# service instance 10 ethernet
Creates a service instance on an interface and defines the
matching criteria.
• instance-id—Integer that uniquely identifies a service
instance on an interface.