Filter
Top Products
12-18
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 12 Configuring Resilient Ethernet Protocol
Configuring Resilient Ethernet Protocol (REP)
Cisco ASR 901 Dual Rep Edge No-Neighbor Topology Example
The following configuration example shows a Cisco ASR 901 router running with Dual REP Edge
No-Neighbor and two Cisco 7600 series routers running as non-REP devices.
Note This section provides partial configurations intended to demonstrate a specific feature.
ASR_1
interface GigabitEthernet0/0
service instance 1 ethernet
encapsulation dot1q 1
rewrite ingress tag pop 1 symmetric
bridge-domain 1
!
service instance 2 ethernet
encapsulation dot1q 2
rewrite ingress tag pop 1 symmetric
bridge-domain 2
!
rep segment 1 edge no-neighbor primary
!
interface GigabitEthernet0/1
service instance 1 ethernet
encapsulation dot1q 1
rewrite ingress tag pop 1 symmetric
bridge-domain 1
!
service instance 2 ethernet
encapsulation dot1q 2
rewrite ingress tag pop 1 symmetric
bridge-domain 2
!
rep segment 1 edge no-neighbor preferred
!
interface Vlan1
ip address 172.18.40.70 255.255.255.128
no ptp enable
!
interface Vlan2
ip address 1.1.1.1 255.255.255.0
no ptp enable
!
interface Vlan3
ip address 2.2.2.2 255.255.255.0
no ptp enable
!
interface Vlan3
ip address 4.4.4.2 255.255.255.0
no ptp enable
!
ip route 3.3.3.0 255.255.255.0 1.1.1.2
ip route 5.5.5.0 255.255.255.0 1.1.1.2
7600_1
interface Port-channel69