24-74
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 24 Configuring QoS
Extending QoS for MLPPP
Configuring a Policy-map to Match on CS5 and EXP4
Complete the following steps to configure a policy-map to match on CS5 and EXP4.
SUMMARY STEPS
1. enable
2. configure terminal
3. class-map match-any class-map-name
4. match ip dscp cs-value
5. class-map match-any exp4
6. match mpls experimental topmost number
7. policy-map policy-map-name
8. class class-name
9. bandwidth percent bandwidth-percent
10. set ip dscp dscp-value
11. class class-name
12. bandwidth percent bandwidth-percent
13. set mpls experminetal topmost number
14. class class-name
15. bandwidth percent bandwidth-percent
16. exit
DETAILED STEPS
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
class-map match-any dscp
cs-value
Example:
Router(config)# class-map match-any
dscpcs5
Configures a class map to be used for matching packets to a specified
class and enters QoS class-map configuration mode.
• class-map-name—The name used for class map.