Filter
Top Products
39-32
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter39 Remote Loop-Free Alternate - Fast Reroute
How to Configure Remote Loop-Free Alternate - Fast Reroute
Verifying Remote LFA-FRR Configuration for EoMPLS on an EVC Interface
To verify the remote LFA-FRR configuration for EoMPLS on an EVC interface, use the show commands
described in the following examples.
Router# show mpls l2transport vc 3001 detail
Local interface: Gi0/0 up, line protocol up, Eth VLAN 200 up
Interworking type is Ethernet
Destination address: 3.3.3.3, VC ID: 1, VC status: up
Output interface: Vl4000, imposed label stack {18 16}
Preferred path: not configured
Default path: active
Next hop: 71.12.1.2
Create time: 00:13:47, last status change time: 00:04:20
Last label FSM state change time: 00:11:54
Signaling protocol: LDP, peer 3.3.3.3:0 up
Targeted Hello: 1.1.1.1(LDP Id) -> 3.3.3.3, LDP is UP
Graceful restart: not configured and not enabled
Non stop routing: not configured and not enabled
Status TLV support (local/remote) : enabled/supported
LDP route watch : enabled
Label/status state machine : established, LruRru
Last local dataplane status rcvd: No fault
Last BFD dataplane status rcvd: Not sent
Last BFD peer monitor status rcvd: No fault
Last local AC circuit status rcvd: No fault
Last local AC circuit status sent: No fault
Last local PW i/f circ status rcvd: No fault
Last local LDP TLV status sent: No fault
Last remote LDP TLV status rcvd: No fault
Last remote LDP ADJ status rcvd: No fault
MPLS VC labels: local 16, remote 16
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
MAC Withdraw: sent:1, received:0
Sequencing: receive disabled, send disabled
Control Word: On (configured: autosense)
Dataplane:
SSM segment/switch IDs: 1434251/4096 (used), PWID: 1
VC statistics:
transit packet totals: receive 0, send 260970
transit byte totals: receive 0, send 24009240
transit packet drops: receive 0, seq error 0, send 0
Local interface: Gi0/0 up, line protocol up, Eth VLAN 200 up
Interworking type is Ethernet
Destination address: 4.4.4.4, VC ID: 1, VC status: standby
Output interface: Vl4000, imposed label stack {21 16}
Preferred path: not configured
Default path: active
Next hop: 71.12.1.2
Create time: 00:13:47, last status change time: 00:14:41
Last label FSM state change time: 00:12:47
Signaling protocol: LDP, peer 4.4.4.4:0 up
Targeted Hello: 1.1.1.1(LDP Id) -> 4.4.4.4, LDP is UP
Graceful restart: not configured and not enabled
Non stop routing: not configured and not enabled
Status TLV support (local/remote) : enabled/supported
LDP route watch : enabled
Label/status state machine : established, LrdRru
Last local dataplane status rcvd: No fault