Filter
Top Products
21-25
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 21 Configuring Pseudowire
Configuring Hot Standby Pseudowire Support for ATM/IMA
Configuring ATM/IMA Pseudowire Redundancy in Port Mode
Complete the following steps to configure pseudowire redundancy in port mode.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-name
4. xconnect peer-ip-address vc-id encapsulation mpls
5. backup peer peer-router-ip-addr vcid
DETAILED STEPS
Step 5
xconnect
peer-ip-address vc-id
encapsulation mpls
Example:
Router(config-if)# xconnect
192.168.1.12 100 encapsulation mpls
Binds an attachment circuit to a pseudowire, and to configure an Any
Transport over MPLS (AToM) static pseudowire.
• peer-ip-address—IP address of the remote provider edge (PE) peer.
The remote router ID can be any IP address, as long as it is reachable.
• vcid—32-bit identifier of the VC between the routers at each end of
the layer control channel.
• encapsulation—Specifies the tunneling method to encapsulate the
data in the pseudowire.
Step 6
backup peer
peer-router-ip-addr
vcid
Example:
Router(config-if-xconn)# backup
peer 170.0.0.201 200
Specifies a redundant peer for a pseudowire virtual circuit (VC).
• peer-router-id—IP address of the remote peer router.
• vcid—32-bit identifier of the VC between the routers at each end of
the layer control channel.
Command Purpose
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface
interface-name
Example:
Router(config)# interface ATM0/IMA1
Selects the interface.
• interface-name—Name of the interface