37-12
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter37 IPv6 over MPLS: 6PE and 6VPE
How to Configure IPv6 over MPLS: 6PE and 6VPE
Setting up MPLS/IPv4 Connectivity with LDP
To configure MPLS and IPv4 connectivity with LDP, complete the following steps:
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface
4. ip address ip-address
5. mpls ip
6. exit
DETAILED STEPS
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface
interface-name
Example:
Router(config)# interface vlan 100
Configures an interface type and to enter interface configuration
mode.
• interface-name—Interface name.
Step 4
ip address
ip-address
Example:
Router(config-if)# ip address 1.1.1.1
255.255.255.0
Sets a primary or secondary IP address for an interface.
Step 5
mpls ip
Example:
Router(config-if)# mpls ip
Enables MPLS forwarding of IP packets along normally routed
paths for a particular interface.
Step 6
exit
Example:
Router(config-if)# exit
Exits interface configuration mode.