41-8
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 41 IPv4 Multicast
Configuring IPv4 Multicast
DETAILED STEPS
Configuring PIM SSM Mapping
To configure PIM SSM mapping, complete the following steps:
SUMMARY STEPS
1. enable
2. configure terminal
3. no ip igmp ssm-map query dns
4. ip igmp ssm-map enable
5. ip igmp ssm-map static access-list source-address
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
ip pim ssm [default | range
access-list
]
Example:
Router(config-if)# ip pim ssm default
Configures SSM service. The default keyword defines the SSM
range access list. The range keyword specifies the standard IP
access list number or name that defines the SSM range.
Step 4
interface
type number
Example:
Router(config)# interface
GigabitEthernet 0/1
Specifies an interface type and number, and places the device in
interface configuration mode.
Step 5
ip pim sparse-mode
Example:
Router(config-if)# ip pim sparse-mode
Enables PIM on an interface.
Step 6
ip igmp version 3
Example:
Router(config-if)# ip igmp version 3
Enables IGMPv3 on an interface.