Filter
Top Products
24-55
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 24 Configuring QoS
Configuring Quality of Service (QoS)
Slice allocated to: OAM, Ethernet loopback, Y.1731 DMM
Slice ID: 3
Stage: Ingress
Mode: Double
Entries used: 15/128
Slice allocated to: CESoPSN-UDP, CEF, Layer-3 Control Protocols
Slice ID: 8
Stage: Ingress
Mode: Double
Entries used: 220/256
Slice allocated to: Quality Of Service
Verifying Named Access List
To verify the standard or extended access list configuration, use the show access-lists command as given
below:
Router# show access-lists tes456
Extended IP access list tes456
10 permit ip host 10.1.1.1 192.168.1.0 0.0.0.255
20 permit ip host 10.1.1.1 192.168.2.0 0.0.0.255
30 permit ip host 10.1.1.1 192.168.3.0 0.0.0.255
40 permit ip host 10.1.1.1 192.168.4.0 0.0.0.255
50 permit ip host 10.1.1.1 192.168.5.0 0.0.0.255
60 permit ip host 10.1.1.1 192.168.6.0 0.0.0.255
70 permit ip host 10.1.1.1 192.168.7.0 0.0.0.255
80 permit ip host 10.1.1.1 192.168.8.0 0.0.0.255
90 permit ip host 10.1.1.1 192.168.9.0 0.0.0.255
!
!
!
To verify the ACL-based QoS classification, use the show policy-map command as given below:
Router# show policy-map interface gigabitethernet 0/0
GigabitEthernet0/0
Service-policy input: test
Class-map: test (match-any)
0 packets, 244224 bytes
5 minute offered rate 6000 bps, drop rate 0000 bps
Match: access-group name test
QoS Set
dscp af32
Packets marked 0
No marking statistics available for this class
Class-map: class-default (match-any)
0 packets, 239168 bytes
5 minute offered rate 6000 bps, drop rate 0000 bps
Match: any