28-4
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 28 Configuring Link Layer Discovery Protocol
Configuration Example for LLDP
Verifying LLDP
To verify LLDP on the Cisco ASR 901 router, use the show command as shown in the following
example.
Router# show lldp ?
entry Information for specific neighbor entry
errors LLDP computational errors and overflows
interface LLDP interface status and configuration
neighbors LLDP neighbor entries
traffic LLDP statistics
| Output modifiers
<cr>
Router# show lldp entry *
Capability codes:
(R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device
(W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other
Configuration Example for LLDP
This section provides the following configuration examples:
• Example: Enabling LLDP Globally
• Example: Configuring Hold Time
• Example: Configuring Delay Time
• Example: Configuring Intervals
Example: Enabling LLDP Globally
Router> enable
Router# configure terminal
Router(config)# lldp run
Router(config)# end
Example: Configuring Hold Time
Router> enable
Router# configure terminal
Router(config)# lldp holdtime 100
Router(config)# end