Filter
Top Products
10-13
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 10 Configuring Ethernet OAM
Note Use the no form of each command to remove a configuration or to return to the default settings.
Configuring Static Remote MEP
Complete the following steps to configure Ethernet CFM static remote MEP:
Note Use the no form of each command to remove a configuration or to return to the default settings.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ethernet cfm domain domain-name level level-id Define a CFM domain, set the domain level, and enter
ethernet-cfm configuration mode for the domain. The
maintenance level number range is 0 to 7.
Step 3
service { short-ma-name | number MA-number |
vlan-id primary-vlan-id | vpn-id vpn-id } {vlan
vlan-id | port | evc evc-name }
Configure the maintenance association and set a
universally unique ID for a customer service instance (CSI)
or the maintenance association number value, primary
VLAN ID and VPN ID within a maintenance domain in
Ethernet connectivity fault management (CFM)
configuration mode.
Step 4
continuity-check Enable sending and receiving of continuity check
messages.
Step 5
mep mpid identifier Define the static remote maintenance end point identifier.
The range is 1 to 8191
Step 6
continuity-check static rmep Enable checking of the incoming continuity check message
from a remote MEP that is configured in the MEP list.
Step 7
end Return to privileged EXEC mode.
Step 8
show ethernet cfm maintenance-points remote
static
Verify the configuration.
Step 9
show ethernet cfm errors [configuration] Enter this command after you enable CFM crosscheck to
display the results of the crosscheck operation. Enter the
configuration keyword to display the configuration error
list.
Step 10
copy running-config startup-config (Optional) Save your entries in the configuration file.