Filter
Top Products
16-8
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 16 Configuring MPLS VPNs
Configuration Examples for MPLS VPN
neighbor 100.0.0.1 activate
neighbor 100.0.0.1 send-community both
exit-address-family
!
address-family ipv4 vrf customer_green
redistribute static
aggregate-address 191.0.0.0 255.0.0.0 summary-only
no synchronization
redistribute connected
neighbor 20.20.30.199 remote-as 200
neighbor 20.20.30.199 activate
exit-address-family
!
address-family ipv4 vrf customer_red
redistribute static
aggregate-address 191.0.0.0 255.0.0.0 summary-only
no synchronization
redistribute connected
neighbor 20.20.30.200 remote-as 100
neighbor 20.20.30.200 activate
exit-address-family
!
!
end
Router_3#show running-config partition router ospf 1
Building configuration...
Current configuration : 220 bytes
!
Configuration of Partition - router ospf 1
!
!
!
router ospf 1
log-adjacency-changes
redistribute connected subnets
network 9.0.0.0 0.0.0.255 area 0
network 20.20.30.0 0.0.0.255 area 0
bfd all-interfaces
!
!
end
Router_3#
Loop Back details
Router_3#show interfaces Loopback 1
Loopback1 is up, line protocol is up
Hardware is Loopback
Internet address is 100.0.1.1/24
MTU 1514 bytes, BW 8000000 Kbit/sec, DLY 5000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation LOOPBACK, loopback not set
Keepalive set (10 sec)
Last input 20:14:17, output never, output hang never
Last clearing of "show interface" counters 22:18:00
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec