Filter
Top Products
12-25
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 12 Configuring Resilient Ethernet Protocol
Configuration Examples for REP
Router# configure terminal
Router(config)# interface gigabitethernet0/1
Router(config-if)# rep segment 1 edge primary
Router(config-if)# rep block port 4 vlan 100-200
Router(config-if)# end
Router(config)# rep platform vlb segment 1 vlan 100-200
Figure 6 Example of VLAN Blocking
Setting up the Preemption for VLAN Load Balancing: Example
The following is an example of setting the preemption for VLAN load balancing on a REP segment.
Router> enable
Router# configure terminal
Router# rep preempt segment 1
Router# end
Configuring SNMP Traps for REP: Example
This example shows how to configure the router to send REP traps at a rate of 10 traps per second:
Router> enable
Router# configure terminal
Router(config)# snmp mib rep trap-rate 10
Router(config)# end
Monitoring the REP Configuration: Example
The following is sample output of the show interface rep detail command. Use the show interface rep
detail command on one of the REP interfaces to monitor and verify the REP configuration.
Router# show interface gigabitethernet0/1 rep detail
GigabitEthernet0/1 REP enabled
Segment-id: 2 (Edge)
PortID: 00010019E7144680
Preferred flag: No
Operational Link Status: TWO_WAY
Current Key: 0002001121A2D5800E4D
Port Role: Open
Blocked Vlan: <empty>
E2E1
4
201891
Alternate port (offset 4)
blocks VLANs 100-200
Primary edge port E1
blocks all VLANs except
VLANs 100-200