23-8
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 23 Cisco IOS IP SLA
Two-Way Active Measurement Protocol
Configuring the TWAMP Reflector
The TWAMP server and reflector functionality are both configured on the same device.
Complete the following steps to configure the TWAMP reflector:
SUMMARY STEPS
1. enable
2. configure terminal
3. ip sla responder twamp
4. timeout seconds
5. end
Configuration Examples for TWAMP
This section provides the following configuration examples:
• Example: Configuring the Router as an IP SLA TWAMP server
• Example: Configuring the Router as an IP SLA TWAMP Reflector
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 1
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 2
ip sla server twamp
Example:
Router(config)# ip sla server twamp
Configures the switch as a TWAMP responder, and enter TWAMP
configuration mode.
Step 3
timer inactivity
seconds
Example:
Router(config-twamp-srvr)# timer
inactivity 300
(Optional) Sets the maximum time, in seconds. The session can be inactive
before the session ends. The range is between 1 to 604800 seconds. The
default is 900 seconds.
Step 4
end
Example:
Router(config-twamp-srvr)# end
Return to privileged EXEC mode.