A SERVICE OF

logo

13-5
Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09
Chapter 13 Configuring MST on EVC Bridge Domain
Contents
Figure 13-2 MST with untagged EVCs without loop
Complete the following steps to configure MST on EVC bridge domain.
Command Purpose
Step 1
enable
Example:
Router# enable
Enables privileged EXEC mode.
Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface gigabitethernet
slot/port
Example:
Router(config)# interface
gigabitethernet 0/1
Specifies the gigabit ethernet interface to configure.
slot/port—Specifies the location of the interface.